The sludge filter press is a device that applies mechanical force to the filtration side to filter solid and liquid from the sludge (water). The drive chain of the speed-controlled motor is lubricated once a month for normal operation. The sludge filter press is used for sludge dewatering in wastewater treatment, pharmaceutical, electroplating, papermaking, leather, printing and dyeing, metallurgy, chemical, slaughter, food, brewing and environmental protection. The sludge filter press can also be used in industrial production. In the environment of solid-liquid evacuation, the sludge filter press can also be applied to the process of solid-liquid evacuation or liquid leaching in industrial production. It is widely used in domestic environmental protection projects. First of all, whether the electromechanical department of the sludge filter press is too clean, whether the fine pump and mud are clean, and whether the anchor screws are loose. Check the sludge obfuscator, drug obfuscator and belt sludge dehydrator reducer for rigid lubricants and whether the screws are loose. Atmosphere compressor and the transmission department of the conveyor belt should be regularly refueled to connect the oil level and the atmosphere tank of the atmosphere compressor once a day. If the travel switch and solenoid valve are damaged before driving, please change them in time. The pneumatic department of the sludge filter press is too thin to compress the atmosphere tube, do not fight Mars and squeeze. The oil cup and oil level in the control tank should be connected to the liquid level to ensure the normal operation of the fuel tank. Sludge filter press transmission components. The transmission chain of the speed control motor is added with butter once a month to connect the normal operation. All bearings of the degreasing machine are lubricated with a grease gun once a month. Bearings for deflection and tension intermediate shafts should be lubricated every three months. Make sure that all conditioning and tensioning sliders do not rust. Use a grease gun once a week to ensure lubrication and mobility. All fasteners and bearing housings of the sludge treatment system are greased once a month to ensure that the parts will not corrode sewage and sludge air.